With the new Bluetooth pairing module, it is now easier than ever to pair the new Near GU10 smart bulb. Once you power on the new GU10 bulb, if it is flashing rapidly, tap on the "+" top right hand of the home screen and a prompt would surface. Simply follow the steps:
If the prompt didn't surface, follow the default method for pairing:
Default Method (EZ Mode):
Step 1: Power on your device.
Step 2: Turn On (3s) - Off (3s) 5 times.
Step 3: When your device is flashing rapidly (x2 times per second) it is now ready to be paired.
Step 1: Power on your device. Turn it OFF after 10 seconds.
Step 2: Turn On (3s) -Off (3s) 5 times
Step 3: When your device is flashing rapidly (x2 times per second), proceed to the next step.
Step 4: Operate again: (Turn ON - Turn OFF) and repeat x3 times.
Step 5: Once the light is slowly flashing, your device is now ready to be paired in AP Mode.